![]() ![]() ![]() When I cleaned mine, I used a 4-1 water/acid mix. Hand tighten unions before restoring power to filter pump. If not, repeat cleaning procedure.ĩ) Rinse cell with fresh water and replace in plumbing line. Look in both ends of the cell to confirm calcium deposits are removed. You will be submersing the cord, which will not be affected by the mild acid solution. Let the cell sit in this solution for 5-10 minutes.ħ) Turn the cell over and let the other end sit in the solution for 5 - 10 minutes. My question for all you pool guru's is: how do I disconnect the Turbo Cell from the water line, without having water spill all over the place?Ģ) Remove the AquaRite Turbo Cell from its position in the plumbing by loosening the unions on both ends of the cell.ģ) You will need a small plastic bucket (6 - 8" opening), water and muriatic acid.ĥ) Set the Turbo Cell, on end, in the bucket of water.Ħ) Add 1 - 1 1/2" of muriatic to the water in the bucket. I've found the below directions on a couple of spots on the Internet. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |